anvilfire home Blacksmithing News and Events Cyber Smiths Int.
Edition 35 - Page 7 of 18 September 24, 2004
B² Design Power Hammer School Mooresville, North Carolina
	Isolating the stock for a ball end on the narrow section of the combination dies.
Drawing out the Long Taper on the wide section of the combination dies. Then chamfering the corners.
	Zeevik Gottlieb demonstrating This simple excersize took me several tries to get the ball the right size. It is easy to make it to long or too short. Pieces from this excersize were used to make the coat hook shown on pages 3 and 4 and below.
	At Left the ball end has been flattened.
Page 1  Page 2  Page 3  Page 4  Page 5  Page 6  [ ]   Page 8  Page 9  Page 10  NEWS HOME
September 24, 2004 Edition B² SCHOOL, SOFA, TURLEY Comments to: Editor at anvilfire.com	Copyright © 2004 by Jock Dempsey   -