International Technical Ceramics products sold by Dempsey's Forge

  ITC-100 HT Ceramic Coating
Surface Preparation
Remove all loose and weakened fiber, bricks, debris, particles, dust and grease from interior walls, door, crown, floor and grooves behind electrical elements. Immediately before applying ITC-100 HT, dampen surface by spraying lightly with water.
Mixing - Dilution
To 1 part   ITC-100 HT add 1/2 part water by volume and mix well. Power mixing is required for large quantities. Mixing then letting set for a few hours or overnight then mixing again produces a smooth mixture.
Applying
Spray large surfaces using a texture paint system of the type used for ceilings. A canister type spray gun with nozzle suitable for ceramics can be used for medium size surfaces. Agitate as necessary to prevent settling. For small areas a brush can be used. Generally an inexpensive 1" (25mm) brush is suitable but for tight places a large artist's paint brush of about 1/2" (12mm) works well.

When brushing onto ceramic fiber two coats are usually needed. The first coat may be fired briefly prior to second coat.

  ITC-296 A High Purity Ceramic Coating
Surface Preparation
Apply ITC-100 HT or other ITC products according to instructions. Fire thoroughly (ITC recommends two or three times) before applying ITC-296A.
Mixing - Dilution
To 1 part   ITC-100 HT add 1/2 part water by volume and mix well. Power mixing is required for large quantities. Mixing then letting set for a few hours or overnight then mixing again produces a smooth mixture.
Applying
Spray large surfaces using a texture paint system of the type used for ceilings. A canister type spray gun with nozzle suitable for ceramics can be used for medium size surfaces. Agitate as necessary to prevent settling. For small areas a brush can be used. Generally an inexpensive 1" (25mm) brush is suitable but for tight places a large artist's paint brush of about 1/2" (12mm) works well. A thin top coat of a maximum of 1/32" (.08 mm) is all that is necessary.

  ITC-213 Ceramic Coating for Metals
Surface Preparation
Remove all loose rust layers, grease, dirt and molten metal or scale buildup. If possible roughen the surface by using a file or hacksaw blade. Sandblasting is not recommended but is not detrimental. Wash surface with a 1 : 1 solution of liquid Chlorox bleach and water. DO NOT use solvent based degreasers.
Mixing - Dilution
To 1 part ITC-213 add 1/3 part water by volume and mix well. Power mixing is required for large quantities. Mixing then letting set for a few hours or overnight then mixing again produces a smooth mixture.
Applying
The best results are obtained by using a paint edger or a piece of cloth dipped in the ITC-213 and then vigorously rubbing the coating onto the surface as thinly as possible. A thin top coat is all that is necessary.
Copyright © 2011 anvilfire.com