anvilfire.com flaming anvil trademark logo copyright (c) 1998 Patrick J. Dempsey
     HOME!   |   STORE   |   Getting Started in Blacksmithing    
 
   Guru's Den   
   Slack-Tub Pub II   
   Tailgate Sales   
   FAQs   
   Glossary   
   Plans   
   Armoury   
   iForge How-To    
   Health and Safety   
   Book Reviews    
   eBooks On-line   
   Anvil Gallery   
   Vice Gallery   
   Story Page   
   AnvilCAM - II   
  Touchmark Reg.  
   Power Hammers   
   What's New   
Comic of the Week
   Daily Comics   
Daily Metalworking Comics!
   Webring Nexus   
   Our Sponsors   

Tell them you found it on anvilfire.com!

Anvils in America, THE book about anvils

Blacksmithing and metalworking questions answered.



Blacksmithing and Metalworking Tools Historical Preservation.

International Ceramics Products

Foot Treadle Grinder

Foot Treadle Grinder built by Jock Dempsey 1970
Foot Treadle Grinder on Wooden Stand - By Jock Dempsey

I bought this old grindstone from an antique dealer on the horseshoe bend near Eagle Irie on highway 501 in Bedford County Virginia. That was in the days back when they had a roadside zoo with a starving scroungy old lion in a cage.

The stone was on a rickety stand with the wheel sitting loose on the shaft where it had been operated for many years at about a 15 degree angle wearing the wheel crooked and out of round. I did not know at the time that these stones were wedged on the square shaft with wooden wedges. So I cemented it on with a Portland cement sand mix.

I built the stand and made the few metal pieces (the crank and connecting end) which were my first forgings. The frame is pine 2x12 and 2x4's. I spend many hours pumping the treadle grinding on old rasps using them like scrapers to try to true the stone. It is now square but still runs out a lot - maybe an inch.

These old stones are quite soft and grind very slowly, more like polishing. They could be used to put a finished edge on a tool but would be very slow to shape a tool. It helps to have a can dripping water on the wheel when grinding OR for it to pass through a trough of water. Wheels should not be left standing in water as it softens the stone AND it results in an unbalanced wheel.


References and Links


Copyright © 1998, 2024 anvilfire.com